Metal or thick phone cases can interfere with the magnetometer signal. Remove the case before scanning to get the clearest readings. If your case is plastic or silicone, it usually won't affect results, but removing it is still a good habit.

Launch the app and hold your phone away from the wall — ideally in the center of the room. The app will read the ambient magnetic field at this baseline level. This calibration step ensures the readings you see near the wall reflect actual changes, not background noise. Most versions of the app prompt you to calibrate automatically on first launch.

Studs in North American homes are typically placed 16 inches apart (sometimes 24 inches in newer construction or garage walls). Starting from a corner gives you a predictable baseline — the first stud is usually 15.25 inches from the corner (to allow for the 0.75 inch corner drywall). In European construction, stud spacing varies more, so don't rely on spacing assumptions — trust the sensor readings.

Hold your phone flat against the wall surface, with the back of the phone pressed gently against the drywall. Slowly move it horizontally across the wall at a consistent height (about chest level works well). Keep your movement steady — about 5 centimeters per second. Watch the app's magnetometer graph as you move.

As you pass over a metal screw or nail (which marks a stud's location), the magnetometer reading will spike upward. The app will typically highlight this with a visual indicator and may trigger a vibration or sound alert. The peak of the spike is directly over the metal fastener — and the stud is right behind it.

Note: You may see multiple small spikes if there are several screws along a single stud. This is normal. A stud typically has screws every 8–12 inches vertically.

When the spike peaks, hold the phone still and mark the spot on the wall with a small pencil mark or a strip of painter's tape. Painter's tape is ideal because it leaves no residue and is highly visible.

Remove your marks and repeat the scan. Do this at least twice — once at chest height and once at a different height (higher or lower by 20 cm). If both passes show a spike at the same horizontal position, you've confirmed a stud. If the spike location shifts between passes, it may be a false positive from a pipe, metal bracket, or electrical box rather than a stud.

Most studs are 1.5 inches (38mm) wide. The screw is usually centered on the stud. So if you find a spike at position X, the stud runs from X - 0.75 inches to X + 0.75 inches. For heavy loads, try to drill near the center of the stud (at the spike) rather than near the edge.

Once you've found one stud, look for the next one at 16 inches (or 24 inches) to either side. Scan again to confirm. Repeat across the wall until you have all the stud locations marked.

If you see no spikes, the wall may have very few screws (older nail-only construction), or you may be moving too fast. Try slowing down your scan speed significantly.

If the reading is permanently high everywhere, you may be near a large metal object (radiator, metal stud wall, steel beam) or have not calibrated the app in a neutral location. Recalibrate away from the wall.

Electrical boxes, pipe brackets, and corner beads can all cause spikes. If a spike doesn't conform to the regular 16-inch stud pattern, investigate further by tapping the wall — a stud produces a solid thud, while empty drywall sounds hollow.